The Trimming Presses are used for demurring the flashes in castings of Aluminum, Magnesium and Zinc as shown in Images, which are casted from High Pressure Die Casting Machine (HPDC) and Gravity Die Casting Machine. As it is not Practical to Machine the Flashes therefor to debur the Flashes Micro Has Designed and Developed a Hydraulic Trimming Press Machine Solution to Remove the Flashes .
To debur the flashes and make a perfect component , The casted component is Positioned Manually or by Robot in the Lower Part of the Trim Die , After keeping the Component machine has to be in Cycle Start mode then the upper part of Cutting Die travel to the Component and remove the Flashes . The Pressure and Speed of The Machine can be set manually or Trough HMI . once the extra Material from Casting has been removed, these flashes will be removed from the dies and the finished component can be collected from the Bottom of the Machine . All Components are collected at the Bin Placed at the Bottom of the Machine . As shown in Video below: